Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  WinPCSIGN, error messages and solution  ~  Engraving

BaiCam
Posted: Sat Aug 19, 2006 9:18 am Reply with quote
Joined: 18 May 2006 Posts: 16
in engrave mode can you set a tool path i.e. for fills other than the letters for reverse engraving routering ,is there different tool cut paths to select i.e. s sweep fills etc thanks
View user's profile Send private message Send e-mail Visit poster's website
Pierre
Posted: Wed Aug 23, 2006 2:53 pm Reply with quote
Site Admin Joined: 24 Jan 2006 Posts: 151 Location: Montreal
Yes you can manage many tool path direction. You have a sweet fill. See the panel for the engraving.

View user's profile Send private message Send e-mail Visit poster's website
BaiCam
Posted: Wed Aug 23, 2006 4:06 pm Reply with quote
Joined: 18 May 2006 Posts: 16
Where in winPCSIGN is the Engraving panel?
View user's profile Send private message Send e-mail Visit poster's website
BaiCam
Posted: Wed Aug 23, 2006 4:10 pm Reply with quote
Joined: 18 May 2006 Posts: 16
I have found that but are there any other instructions for Engraving anywhere?
View user's profile Send private message Send e-mail Visit poster's website

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum