Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  WinPCSIGN Software  ~  Problem with WinPCSIGN and Roland PNC-1000 communicating

mark
Posted: Fri Sep 23, 2011 3:31 pm Reply with quote
Joined: 21 Sep 2011 Posts: 1
I followed your instructions and I believe the 2 are communicating now but the read-out on the Roland screen says "ESC. Error 16 Please see manual" - but my manual doesn't name error 16 and tell me the fix. However, I did find a manual of a PNC-900 on line from an that states "Cause: the I/O buffer overflows. Action: This error does not occur when hardware handshake is performed, but may occur when software handshake is performed. If this error occurs, check the remaining buffer capacity of the PNC-900 and send less data than the remaining buffer capacity".
Hope you can help.
One more thing. I pressed the FUNC key after the message appeared and the cutter carriage moved over to the left and cut part of the image I sent to be cut.
View user's profile Send private message
Ivan
Posted: Tue Sep 27, 2011 5:23 pm Reply with quote
Joined: 19 Apr 2007 Posts: 357 Location: Montreal
You need to contact Roland company

http://www.rolanddga.com/


Last edited by Ivan on Wed Sep 28, 2011 1:17 pm; edited 1 time in total

_________________
Ivan Polanco, Sales manager/Support
Signmax.us Profesionnal signmaking ressources
View user's profile Send private message Send e-mail Visit poster's website

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum