Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  WinPCSIGN Software  ~  panels on both axis

antonio.collado
Posted: Wed Aug 14, 2013 10:20 pm Reply with quote
Joined: 27 Sep 2009 Posts: 1
My instruction manual when explainning cutting panels, only explains the panels one on top of the other. I would like to know if the panels that go side by side can be shown the limits where one starts and ends.
For example I have an area to cut a logo of 144" long and 96" wide, but I would like to cut it in pieces of 60" lon and 18" wide. (Can not see the 101,102 etc divisions)

Thanks in advance.
View user's profile Send private message
Ivan
Posted: Tue Sep 17, 2013 1:38 pm Reply with quote
Joined: 19 Apr 2007 Posts: 356 Location: Montreal
The software show the panels 101,201,301 etc if your job is higher of your vinyl put on the cutter.
The panels (101,201.) will be show if the value in MATERIAL options (cutting control panel) is smaller of your job height.

Most of the vinyl cutter on the market removed the maximum length option (101,102,103 etc) but, you changed the value from Page length.
from Plotter code/Hardware/Paper lenght

_________________
Ivan Polanco, Sales manager/Support
Signmax.us Profesionnal signmaking ressources
View user's profile Send private message Send e-mail Visit poster's website

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum