| Author |
Message |
|
| mgsmos |
 Posted: Thu Jul 06, 2006 1:48 pm |
 |
|
|
Joined: 06 Jul 2006
Posts: 2
|
Hi Everyone,
I am new to this. I was wondering how do i apply the film to a surface without the vinyl sticking to itself. Any help or were to find this information would be helpful
Cheers
Marc |
|
|
| Back to top |
 
|
| HUNTERSPEEDWORKS |
| Posted: Tue Jul 18, 2006 5:03 pm |
|
|
|
Joined: 14 Jul 2006
Posts: 5
|
Mostly you just figure it out. There are some books available on how to apply vinyl. Check with the place that you bought the vinyl.
If you're working with a large piece than I only cut off a 2-3 inch section straight across. Then once it is in place you can pull the rest of the backing off slowly as you lay down the exposed part. Also you can float it if it's rather large. Get some application fluid to help with this. |
|
|
| Back to top |
|
| kenb |
| Posted: Sat Aug 19, 2006 6:34 pm |
|
|
|
Joined: 23 Apr 2006
Posts: 15
Location: Eagle Bay, BC
|
Are you familiar with transfer tape? You use it to lift the cut vinyl away from the backing paper then lay your graphic down using the transfer tape , then remove the transfer tape. You can do this wet or dry using the hinge method.
Ken |
|
|
| Back to top |
|
|
|
